User and Installation Manual - Cyclone wind turbines

More documents

Recommendations

Info

Annular anchors need to be set 60°to 80°along the base direction, check the distance between the four anchor hooks and the center of the base. The four anchors should be horizontal (as shown in diagram 3). Diagram 3
Tower assembly Insert the main section of tower into the base, then insert the axis pin or bolt into the base and tighten. Connect each section of tower one by one and place the tower on the supporting stand after assembly. Pass a flexible conduit through each tube section for cables. Fix the guy wires Cut the cables to approximate lengths and lay out the four cables towards each anchor point. Attach all four cables to the mast fixing points. Please note that taller towers will have eight cables. Make sure that the loaded cable is underneath the clamp as shown above.
Page 1 and 2: User and Installation Manual 500W,
Page 3 and 4: General data Protection Level Insul
Page 5 and 6: Inverter Cyclone wind turbines can
Page 7 and 8: For free standing tower (refer to f
Page 11 and 12: Electrical wires Model 300W 500W 10
Page 13: Determine Location for Tower Base S
Page 17 and 18: Fix the lower pulley on the front a
Page 19 and 20: Turbine assembly and connections Li
Page 21 and 22: After adjusting the distance betwee
Page 23 and 24: Wiring options - Island grid batter
Page 25 and 26: Off-grid typical system connections
Page 27 and 28: The system will continuously check
Page 29 and 30: FREQUENTLY ASKED QUESTIONS Why does
Page 31: Safety Information Wind turbines pr

User and Installation Manual - Cyclone wind turbines

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?