User and Installation Manual - Cyclone wind turbines
User and Installation Manual - Cyclone wind turbines
User and Installation Manual - Cyclone wind turbines
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Wiring options – Grid connection<br />
(Special attention to 3kw & above 3kw)<br />
There are two cables connected to the generator head. One is the <strong>wind</strong> direction signal cable, which<br />
has an aviation plug on the cable head. You need to insert this plug into the socket. The other cable is<br />
for the output of generator power <strong>and</strong> the controlling signal. There are five lines with three thick wires for<br />
generator output <strong>and</strong> the other two thin wires for controlling signal, which is classified as positive<br />
electrode <strong>and</strong> negative one. All should be appropriately connected to the connecting poles at the<br />
back of controller.<br />
The anemoscope<br />
The anemoscope should be installed on a house roof or in an open area on a<br />
separate mast, <strong>and</strong> must be vertical. One end of the anemoscope cable<br />
should be inserted into the socket under the anemoscope with the other end<br />
inserted into the appropriate socket in the controller.