User Manual - John Preston

More documents

Recommendations

Info

1.18 Control unit length adjustment 23 – Loosen the two screws [42] in the bracket [43] situated underneath the armrest. 42 – Push the bracket holding the control unit to the desired position. – Tighten the two screws [42] again.
2 Settings on the control unit 24 2.1 General information regarding programming mode In order to meet the different requirements of customers and the various sorts of disablement, the adventure provides a wide range of variable driving parameters. Programming can be carried out directly via the control unit without any additional device. Only a programming key, which is delivered with every new adventure, is needed. Programmierschlüssel Programming key ! For safety reasons, the programming key should not be given to the user. Driving parameters must only be changed by qualified persons (e.g. a therapist, a specialist dealer). After the program has been changed, a trial run should be undertaken, supervised by a qualified person, to ensure that the user can cope with the new driving characteristics. 2.2 Driving programs There are two driving programs available for the adventure – Indoor and Outdoor modes. To a great extent, both modes can be programmed independently of each other, so that travel indoors can be based on different parameters from travel outdoors. It is also possible to make individual settings to reflect the state of health and disablement of the wheelchair occupant. The essential differences between the two modes are: – In Outdoor mode the wheel at the outside of a curve is accelerated, resulting in nimble driving conduct – In Indoor mode the wheel at the inside of a curve is braked, resulting in driving conduct that is tolerant and predictable
Page 1 and 2: Adventure A10 Informationen für Th
Page 3 and 4: Contents 1 Mechanical adjustments
Page 5 and 6: 1 Mechanical adjustments to the adv
Page 7 and 8: 1.3 Armrest sideways adjustment 9 -
Page 9 and 10: 1.5 Backrest angle of inclination a
Page 11 and 12: 10 1.7 Seat length adjustment Funct
Page 13 and 14: 12 1.9 Leg support length adjustmen
Page 15 and 16: 14 1.11 Leg support footrest length
Page 17 and 18: 16 1.13 Adjusting the chassis sprin
Page 19 and 20: 18 31 1.14 Setting the direction in
Page 21 and 22: 20 1.16 Setting the seat position S
Page 23: 22 1.17.2 Mudguards for the powered
Page 27 and 28: 26 Turning speed - Determines the m
Page 29 and 30: 28 Speed reduction This parameter c
Page 31 and 32: 30 2.6 Changing the parameters Afte
Page 33 and 34: 32 2.8 Parameter table 2.8.1 advent
Page 35 and 36: 34 2.8.3 adventure version 12 km/h
Page 37 and 38: 36 Drive symbol flashes Exclamation
Page 39 and 40: 38 Drive symbol flashes Exclamation
Page 41 and 42: 40 Interface symbol flashes Exclama
Page 43 and 44: 42 Complete seat unit* flashes Inte
Page 45 and 46: 44 Brake symbol flashes Battery cap

User Manual - John Preston

Create successful ePaper yourself

Delete template?

Save as template?