User Manual - John Preston

More documents

Recommendations

Info

1.4 Backrest height adjustment Only Function seat (comfort and standard upholstery) 11 – Remove the cushion from the backrest. – Loosen and remove the 4 screws that hold the backrest to the support bracket [11]. – On the inside of the backrest there are 3 holes in each of two rows which are normally covered by the upholstery. Feel for these holes with a sharp object. 12 12 12 12 – Select the hole [12] which will provide the desired height for the backrest. – With a sharp knife, cut an opening into the upholstery over the chosen holes. – As an alternative to a knife a soldering iron may also be used. When the screw holes melt it should leave an even, clean and heat-sealed border around the holes. – Screw the backrest back onto the support bracket [11] in the height position you have selected. – Replace the cushion on the backrest.
1.5 Backrest angle of inclination adjustment Function seat 14 – Loosen the screws [13] in the support bracket. 11 – Push the entire backrest [14] to the desired angle of inclination. – Tighten the screws [13] again. 13 13 ! By adjusting the angle of inclination, the height of the backrest is also altered. It may be necessary to re-set the height (see chapter 1.4).
Page 1 and 2: Adventure A10 Informationen für Th
Page 3 and 4: Contents 1 Mechanical adjustments
Page 5 and 6: 1 Mechanical adjustments to the adv
Page 7: 1.3 Armrest sideways adjustment 9 -
Page 11 and 12: 10 1.7 Seat length adjustment Funct
Page 13 and 14: 12 1.9 Leg support length adjustmen
Page 15 and 16: 14 1.11 Leg support footrest length
Page 17 and 18: 16 1.13 Adjusting the chassis sprin
Page 19 and 20: 18 31 1.14 Setting the direction in
Page 21 and 22: 20 1.16 Setting the seat position S
Page 23 and 24: 22 1.17.2 Mudguards for the powered
Page 25 and 26: 2 Settings on the control unit 24 2
Page 27 and 28: 26 Turning speed - Determines the m
Page 29 and 30: 28 Speed reduction This parameter c
Page 31 and 32: 30 2.6 Changing the parameters Afte
Page 33 and 34: 32 2.8 Parameter table 2.8.1 advent
Page 35 and 36: 34 2.8.3 adventure version 12 km/h
Page 37 and 38: 36 Drive symbol flashes Exclamation
Page 39 and 40: 38 Drive symbol flashes Exclamation
Page 41 and 42: 40 Interface symbol flashes Exclama
Page 43 and 44: 42 Complete seat unit* flashes Inte
Page 45 and 46: 44 Brake symbol flashes Battery cap

User Manual - John Preston

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?