instructions home cinema dvd/cd control center rx-dv3rsl - JVC

More documents

Recommendations

Info

Getting Started Connecting the FM and AM Antennas AM loop antenna (supplied) If AM reception is poor, connect an outdoor single vinyl-covered wire (not supplied). If FM reception is poor, connect outdoor FM antenna (not supplied). B FM 75 COAXIAL FM 75 COAXIAL AM LOOP FM antenna (supplied) Snap the tabs on the loop into the slots of the base to assemble the AM loop antenna. AM EXT ANTENNA FM 75 COAXIAL 1 2 3 1 FRONT SPEAKERS RIGHT LEFT CENTER SPEAKER RIGHT LEFT REAR SPEAKERS SUB- WOOFER OUT AV IN/OUT DIGITAL 1 (DBS) DIGITAL IN DIGITAL 2 (TV) DIGITAL OUT PCM/STREAM VCR AV IN STB 2 CAUTION: SPEAKER IMPEDANCE 8 16 AV COMPU LINK- TAPE / CDR AUDIO LEFT RIGHT RGB OUT IN (REC) (PLAY) YC TV AM EXT AM LOOP FM 75 COAXIAL ANTENNA Rear panel of the unit AM antenna connection Connect the AM loop antenna supplied to the AM LOOP terminals. 1 Remove the insulation if the AM loop antenna wire is covered with vinyl. 2 Press and hold the clamp of the terminal (1), then insert the wire (2). FM antenna connection Connect the FM antenna supplied to the FM 75 Ω COAXIAL terminal as temporary measure. Extend the supplied FM antenna horizontally. • If the reception is poor, connect an outdoor FM antenna (not supplied). Before attaching a 75 Ω coaxial cable (with a standard type connector), disconnect the supplied FM antenna. 3 Release the clamp. Turn the loop until you have the best reception. • If the reception is poor, connect an outdoor single vinylcovered wire (not supplied) to the AM EXT terminal. Keep the AM loop antenna connected. Note: • Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception. 5
etting Started Connecting the Speakers After connecting the front, center and rear speakers, and/or a subwoofer, set the speaker setting information properly to obtain the best possible Surround effect. For details, see page 24. CAUTIONS: • Use speakers with the SPEAKER IMPEDANCE indicated by the speaker terminals (8 – 16 Ω). • DO NOT connect more than one speaker to one speaker terminal. Connecting the front, center, and rear speakers 1 2 3 2 1 Connecting the subwoofer speaker By connecting a subwoofer, you can enhance the bass or reproduce the original LFE signals recorded in the digital software. FRONT SPEAKERS CAUTION: SPEAKER IMPEDANCE 8 16 RIGHT LEFT RIGHT LEFT CENTER SPEAKER REAR SPEAKERS Powered subwoofer (example) SUB- WOOFER OUT Connect the input jack of a powered subwoofer to the SUB- WOOFER OUT jack on the rear panel, using a cable with RCA pin plugs (not supplied). • Refer also to the manual supplied with your subwoofer. For each speaker, connect the (+) and (–) terminals on the rear panel to the (+) and (–) terminals marked on the speakers respectively. 1 Cut, twist and remove the insulation at the end of each speaker cord (not supplied). 2 Press and hold the clamp of the speaker terminal (1), then insert the speaker cord (2). Note: • You can place a subwoofer wherever you like since bass sound is non-directional. Normally place it in front of you. Speaker Layout Diagram Center speaker Subwoofer 3 Release the clamp. FRONT SPEAKERS RIGHT LEFT RIGHT LEFT CENTER SPEAKER REAR SPEAKERS SUB- WOOFER OUT Left front speaker Right front speaker CAUTION: SPEAKER IMPEDANCE 8 16 To right front speaker To left front speaker To left rear speaker To right rear speaker To center speaker Left rear speaker Right rear speaker FRONT SPEAKERS CAUTION: SPEAKER IMPEDANCE 8 16 RIGHT LEFT RIGHT LEFT CENTER SPEAKER AV COMPU LINK- LEFT RIGHT TAPE / CDR OUT (REC) IN (PLAY) AUDIO RGB REAR SPEAKERS YC SUB- WOOFER OUT VCR TV AV IN/OUT DIGITAL 1 (STB) AV IN DIGITAL IN DIGITAL 2 (TV) STB AM LOOP AM EXT DIGITAL OUT PCM/STREAM FM 75 COAXIAL ANTENNA To obtain the best possible sound from this system, place all the speakers except the subwoofer at the same distance from the listening position with each speaker’s front faced toward the listener. Then, change the subwoofer and speaker settings to fit your listening conditions (see page 24). 6
Page 1 and 2: STB VCR TV AUDIO TV TAPE CDR FM/AM
Page 3 and 4: CAUTION • Do not block the ventil
Page 5 and 6: SAFETY INSTRUCTIONS “SOME DOS AND
Page 7 and 8: COMPACT SUPER VIDEO Parts Identific
Page 9: Getting Started Before Installation
Page 13 and 14: ing Started Turn off all the compon
Page 15 and 16: ng Started VCR STB (Set Top Box) TV
Page 17 and 18: Operations Turning Off the Sounds T
Page 19 and 20: asic Operations Attenuating the Inp
Page 21 and 22: asic DVD Player Operations 4 Adjust
Page 23 and 24: uner Operations 7 To tune in a pres
Page 25 and 26: tions Searching for a Program by PT
Page 27 and 28: tions Description of the PTY codes:
Page 29 and 30: asic Settings 7 Speaker information
Page 31 and 32: asic Settings 7 Auto surround—“
Page 33 and 34: ound Adjustments 7 Front speaker ou
Page 35 and 36: Realistic Sound Fields The followin
Page 37 and 38: eating Realistic Sound Fields Adjus
Page 39 and 40: Player Operations 7 Disc structure
Page 41 and 42: VD Player Operations Basic Operatio
Page 43 and 44: 1/3 1 3/3 3 2/3 2 VD Player Operati
Page 45 and 46: VD Player Operations 3 Press cursor
Page 47 and 48: VD Player Operations To turn off th
Page 49 and 50: VD Player Operations To move the zo
Page 51 and 52: VD Player Operations Repeat Playbac
Page 53 and 54: layback Operations through the MP3
Page 55 and 56: c Playback Notes: • The following
Page 57 and 58: ice Menu Operations Operating Proce
Page 59 and 60: hoice Menu Operations MP3/JPEG If
Page 61 and 62:
hoice Menu Setting Operations DVD p
Page 63 and 64:
e Menu Operations 7 Changing the se
Page 65 and 66:
Glossary for DVD Player Aspect rati
Page 67 and 68:
perating JVC’s Audio/Video Compon
Page 69 and 70:
perating Other Manufacturers’ Equ
Page 71 and 72:
Maintenance To get the best perform
Page 73 and 74:
leshooting 7 For DVD Player PROBLEM
Page 75 and 76:
Specifications Designs & specificat
show all

instructions home cinema dvd/cd control center rx-dv3rsl - JVC

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?