instructions home cinema dvd/cd control center rx-dv3rsl - JVC

Basic Operations
Selecting the Analog or Digital Input Mode
When you have connected digital source components using both the
analog connection and the digital connection methods (see pages 7 to
10), you can select the input mode.
• Before selecting the digital input mode, register the digital input
terminal setting correctly (see “Digital input (DIGITAL IN)
terminals” on page 25).
1 Press one of the source selecting buttons (STB,
TV, or CDR) for which you want to change the
input mode.
DVD
On the front panel
STB
VCR
TV
TAPE/CDR
SOURCE NAME
TV TAPE CDR FM/AM
FM/AM
Changing the Digital Input Mode Manually
If the following symptoms occur while Dolby Digital or DTS
Digital Surround software is played back, you can change the digital
input mode:
• Sound does not come out at the beginning of playback.
• Noise comes out while searching for or skipping chapters or
tracks.
On the front panel
CONTROL
Press CONTROL 3 (or 2) to select “DGTL D.D.”
or “DGTL DTS” while “DGTL AUTO” still remains
on the display.
• Each time you press the button, the digital input mode changes as
follows:
TV DIRECT
STB
VCR
DVD
DIGITAL AUTO
From the remote control
L
R
VOLUME
Note:
• You cannot change the input mode when selecting DVD as the
source. Digital input is always used for the built-in DVD player.
2 Press INPUT ANALOG/DIGITAL (INPUT ATT.)
on the front panel or ANALOG/DIGITAL INPUT
on the remote control.
INPUT
ANALOG/DIGITAL
INPUT ATT.
On the front panel
ANALOG
/DIGITAL
INPUT
From the remote control
The current input mode appears on the display.
• Each time you press the button, the input mode alternates
between the analog input (“ANALOG”*) and the digital input
(“DGTL AUTO”).
ANALOG/DIGITAL AUTO indicator
DGTL AUTO : Normally select this.
The DIGITAL AUTO indicator lights up.
The unit automatically detects the incoming
signal format, then the sound signal indicator
for the detected signal lights up.
DGTL D.D.
DGTL DTS
DGTL AUTO
DGTL DTS
DGTL D.D.
: Select this for playing back software encoded
with Dolby Digital.
The DIGITAL indicator lights up*.
: Select this for playing back software encoded
with DTS Digital Surround.
The indicator lights up*.
* These indicators flash when no signal or the signal without the
proper format is played back.
ANALOG DIGITAL AUTO
L R
SPK.
DGTL AUTO
ANALOG
VOLUME
When DVD is selected as the source, you can also
change the digital input mode by pressing
ANALOG/DIGITAL INPUT repeatedly on the remote
control.
ANALOG
/DIGITAL
INPUT
* “ANALOG” is the initial setting except for the built-in DVD
player.
DGTL AUTO : Select this for the digital input mode.
The DIGITAL AUTO indicator lights up.
The unit automatically detects the incoming
signal format, then the sound signal indicator
for the detected signal— DIGITAL or
lights up; otherwise, no sound signal indicators
light up.
ANALOG
: Select this for the analog input mode.
The ANALOG indicator lights up.
Notes:
• When “DGTL AUTO” cannot recognize the incoming signals, no
sound signal indicators light up on the display.
• When you turn off the unit or select another source, “DGTL DTS”
and “DGTL D.D.” are canceled.
The digital input mode is automatically reset to “DGTL AUTO.”
13