Dynojet Announces the Dynojet Dynamometer ... - Dynojet Research

FOR IMMEDIATE RELEASE:
Dynojet Announces the Dynojet Dynamometer Torque Module
North Las Vegas, NV, September 28, 2005 — Dynojet is pleased to announce the Dynojet
dynamometer Torque Module accessory for Dynojet dynamometers... another reason we're
leading the way.
The torque module can be retrofitted to any Model
250 or 250i Motorcycle dyno, or 168/188 Kart / ATV
dyno with the eddy current load absorption unit. This
device will allow you to monitor “real time torque” live
on the make-run-screen, as well as performing step
or sweep load tests.
The Torque Module:
• Is an absolute must-have for any dyno shop
looking to optimize spark timing at all load and
RPM ranges.
• Expands the Dynoware EX+ (hardware
stack) and includes the necessary calibration
equipment.
• Performs step or sweep tests with precise
control (see screens on next page).
-more-

Requirements:
Dynojet recommends a computer
system with the following minimum
specifications:
* Processor; Pentium 800 MHz
(minimum)
* Hard Drive; 1.2 Gigabyte
* RAM; 256 Megabyte
* Monitor; 800 x 600, (SVGA),
256 color
* Disc Drives; CD-ROM and
Floppy
* Software; Windows 2000/XP
(Be sure to have original disks)
* Printer; Must be color (We
have found HP DeskJet printers
work well)
* 30 Megabytes of free hard
disk space is required to install
WinPEP
Software
WinPEP 7.1.3 or higher
Hardware
Dynoware EX+ (hardware stack)
Eddy Current Load Control Unit
Contact info:
Dynojet Research
2191 Mendenhall Drive
North Las Vegas, NV 89081
tel: 800 992-3525
email: dynosales@dynojet.com
# # # # #