KM-3050 KM-4050 KM-5050 - kyocera

2GN/2GP/2GR
Section
Operation
panel and
support
equipment
U243 Checking the operation of the DP motors -
U244 Checking the DP switches -
U245 Checking messages -
U246 Setting the finisher
3000-sheet document finisher
Centerfold unit
Built-in finisher
0/0/0/0/0/0 *1
0/0/0/0/0/0/0/0 *1
0/0/0 *1
U247 Setting the paper feed device -
Mode setting U250 Setting the maintenance cycle 400000 (30 ppm) *1,*2
500000 (40/50 ppm) *1,*2
U251 Checking/clearing the maintenance count -
U252 Setting the destination -
U253 Switching between double and single counts Double count *1
U260 Selecting the timing for copy counting After ejection *1,*2
U265 Setting OEM purchaser code 0 *1
U285 Setting service status page ON *1
U326 Setting the black line cleaning indication ON/8 *1,*2
U328 Side ejection setting OFF *1,*2
U332 Setting the size conversion factor 1.0 *1,*2
U341 Specific paper feed location setting for printing function -
U342 Setting the ejection restriction ON *1,*2
U343 Switching between duplex/simplex copy mode OFF *1,*2
U345 Setting the value for maintenance due indication -
Image
U402 Adjusting margins of image printing 74/70/68/85/140/55 *1
processing U403 Adjusting margins for scanning an original on the platen 2.0/2.0/2.0/2.0 *1
Network
scanner
Item
No.
U404 Adjusting margins for scanning an original from the DP 3.0/2.5/3.0/4.0 *1
U407
Content of maintenance item
Adjusting the leading edge registration for memory image
printing
Initial
setting*
3.0/2.5/3.0/4.0 *1
U411 Adjusting the scanner automatically -
U425 Setting the target -
U510 Setting the enterprise mode Inch specifications: ON *1,*2
0 *1
Metric specifications: OFF *1,*2
Others U901 Checking/clearing copy counts by paper feed locations -
U902 Checking/clearing the punch-hole scrap counter 35000/0 *1,*2
U903 Checking/clearing the paper jam counts -
U904 Checking/clearing the service call counts -
U905 Checking/clearing counts by optional devices -
U906 Resetting partial operation control -
U908 Checking the total counter value -
U910 Clearing the black ratio data -
U911 Checking/clearing copy counts by paper sizes -
U920 Checking the copy counts -
U927 Clearing the all copy counts and machine life counts (one
-
time only)
U928 Checking machine life counts -
*Initial setting for executing U020, *1: The item initialized for executing U020, *2: The item initialized for executing U021
1-3-4