SURFboard ® SBV4200 VoIP Cable Modem User Guide ... - Ono

Introduction Before You Begin Installation & Configuration Troubleshooting FAQ
Glossary
License
To avoid damaging your VoIP cable
modem or PC with static electricity:
Always make the
wall connection first.
Before you connect or
disconnect the USB or
Ethernet cable, always
touch the coaxial cable
connector on the VoIP
cable modem.
Precautions
Postpone VoIP cable modem installation until there is no risk of thunderstorm or lightning
activity in the area.
To avoid damaging the VoIP cable modem with static electricity:
■ Always first connect the coaxial cable to the grounded cable TV wall outlet.
■ Before you connect or disconnect the USB or Ethernet cable from your VoIP cable
modem or PC, always touch the coaxial cable connector on the VoIP cable modem
to release any static charges.
To prevent overheating the VoIP cable modem, do not block the ventilation holes on its
sides.
Do not open the VoIP cable modem. Refer all service to your cable service provider.
Wipe the VoIP cable modem with a clean, dry cloth. Never use cleaning fluid or similar
chemicals. Do not spray cleaners directly on the unit or use forced air to remove dust.
Caution
Contact your cable service provider before connecting your VoIP cable
modem to your existing telephone wiring. Do not connect the telephone
wire to a traditional telephone (PSTN) service.
X
Home Print Exit
5 SURFboard ® SBV4200 VoIP Cable Modem User Guide