You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
OPTIONAL ACCESSORY KIT HANGER<br />
If you purchased the optional accessory<br />
kit, these instructions will show you how<br />
to properly assemble it to your machine.<br />
1. Remove the rear panel.<br />
2. Remove the two bolts holding the<br />
balance bar. Have someone support<br />
the bar while you remove the bolts.<br />
REMOVE BOLTS<br />
3. Attach the rubber protector sheet to<br />
the front shroud as shown. First,<br />
clean the shroud area with isopropyl<br />
alcohol and let dry completely.<br />
Remove the backing from the rubber<br />
sheet. Start at the top and align the<br />
holes in the sheet with the holes in<br />
the shroud. Lightly press the sheet<br />
onto the shroud face by working your<br />
way from the top middle, out to the<br />
sides, then work your way down. After<br />
the sheet is in position, apply firm<br />
pressure, starting at the middle and<br />
work your way out toward either side.<br />
4. Place the balance bar over the<br />
accessory hanger plate. Line up the<br />
holes with the holes in the shroud and<br />
reinstall bolts. Hint: It may help to<br />
loosen the bolts on the side of the<br />
balance bar to assist in installing the<br />
bolts. Check the alignment and fully<br />
tighten all bolts.<br />
RUBBER PROTECTOR SHEET<br />
ACCESSORY HANGER PLATE<br />
BALANCE BAR<br />
LOOSEN BOLTS<br />
IF NECESSARY<br />
13
Change language