You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
ASSEMBLING THE MACHINE<br />
ASSEMBLE FEET TO BASE FR<strong>AM</strong>E<br />
INSTALL WEIGHT PLATES<br />
1. Remove the rear panel held in place<br />
by the three thumbscrews at the top.<br />
2. If you ordered the optional adder<br />
weight system, remove the adder<br />
weight guide rods by pulling down on<br />
the adder weight guide rod retainers<br />
at the top of the guide rods. There is a<br />
spring directly under the guide rod<br />
sleeve. Retain it for re-assembly. (see<br />
page 12).<br />
GUIDE ROD RETAINER<br />
CAP PLATE<br />
GUIDE RODS<br />
3. Remove the bolt holding the guide rod<br />
retainer. Slide the guide-rod retainer<br />
up and allow guide rods to tilt toward<br />
the rear of the machine.<br />
4. Lift cap plate off of the guide rods.<br />
5. Install the weight plates, 16 plates<br />
per stack.<br />
6. Re-assemble the cap plate, guide rod<br />
retainers, incremental adder weight<br />
assembly (if ordered) and rear panel.<br />
8