You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
ENGINE & FUEL TANK INSTALLATION<br />
❐ Install the throttle push-rod tube through the firewall and into the<br />
radio compartment. (Photo 62)<br />
Photo 62<br />
❐ Remove the engine and drill a 5/64” (2mm) hole at each of the<br />
marks. (Photo 65)<br />
Photo 65<br />
❐ Leave approximately 1/4” of the push-rod tube extending into the<br />
engine compartment. Epoxy in place. (Photo 63)<br />
Photo 63<br />
❐ Secure the engine to the motor mount using the 4 M3x20 self-tapping<br />
screws provided. Secure the adjustable engine mount at this time<br />
and make sure there is 2-degree right thrust angle. (Photo 66)<br />
Photo 66<br />
❐ Place the engine on the adjustable motor mount and locate the<br />
front drive hub 4-13/16” from the firewall. Mark the mounting hole<br />
locations on the motor mount. (Photo 64)<br />
Photo 64<br />
❐ If installing the recommended Thunder Tiger F-54S engine, extend<br />
the choke valve wire insuring that it is long enough to clear the cowling.<br />
(Photo 67)<br />
Photo 67<br />
15