Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
RADIO INSTALLATION<br />
❐ Install the other end of the throttle push rod in the EZ connector.<br />
Trim off any excess wire (Photo 75).<br />
❐ Mark the other end of the push rod where the “Z” bend is to be<br />
located (Photo 78).<br />
Photo 75 Photo 78<br />
❐ Using a hobby knife carefully cut away the covering over the elevator<br />
and rudder push-rod exits at the rear of the fuselage (Photo 76).<br />
❐ Using “Z” Bend Pliers bend the push rod at the location marked<br />
(Photo 79).<br />
Photo 79<br />
Photo 76<br />
❐ Insert the “Z” bend into the servo horn. Install the servo horn on<br />
the servo (Photo 80).<br />
Photo 80<br />
❐ Install one push rod with the threaded end first through the fuselage<br />
and exiting at the elevator exit slot. Locate a clevis and thread it<br />
onto the threaded end at least 20 turns. Snap the clevis onto the control<br />
horn at the 3rd hole from the bottom (Photo 77).<br />
Photo 77<br />
17