TC35i Module TC35i Terminal

TC35i AT Command Set
Confidential / Released
2.10 ATDL Redial last telephone number used
Execute command
ATDL[;]
This command redials the last voice and data call number used in the ATD command.
To redial the last data call number simply enter ATDL
To redial the last voice call number type ATDL;
The command may be aborted generally by receiving a character during execution.
Abortion is not possible during some states of connection setup such as
handshaking.
Response
If there is no last number or number is not valid:
+CME ERROR
If no dialtone (parameter setting ATX2 or ATX4):
NO DIALTONE
If busy (parameter setting ATX3 or ATX4):
BUSY
If a connection cannot be set up:
NO CARRIER
If successfully connected and non-voice call:
CONNECT TA switches to data state.
Note: output only if +ATX parameter setting with value > 0.
When TA returns to command mode:
OK
If successfully connected and voice call:
OK
Parameter
voice call
Reference
V.25ter
Note
See ATX command in Chapter 2.31 for setting result code and call monitoring
parameters. Refer to Chapter 8.1.4 for .
The last 10 dialed voice call numbers are also stored in the “LD” phonebook.
See Chapter 4.33.
TC35i_ATC_V01.05 Page 28 of 278 04.08.2003