AIR CONDITIONING - Rafstjorn

More documents

Recommendations

Info

3 The cooling unit must be installed as high as possible; 4 If installed on a door, make sure the hinges can withstand the weight of the unit; 5 make sure the electric cable is not torn or damaged when the door is closed; 6 If the depth of the cooling unit prevents the door from being completely opened, arrange a stopper for such a door. 7 Prior to servicing the cabinet, disconnect power supply to the same. Prior to drilling holes or making cuts on the cabinet, make sure that holes, screws, cables, etc. do not interfere with the equipment which has already been installed. Make cuts on the cabinet panels by following the relevant template. 8 Once the anchoring holes have been drilled in the cabinet wall, mount the eyebolts to handle the unit. the necessary cut-outs corresponding to the unit size can be seen on the following pages. 9 Glue the adhesive gasket around the edges of the holes drilled on the cabinet; 10 Position the cooling unit at the cabinet and secure it with the appropriate screws. adhesive gasket threaded inserts NOTE: Compact-Air units are already provided with threaded inserts, in correspondance with the fixing holes at the cut-out. Therefore the fixing holes at the cabinet wall must not be provided with threaded inserts. threaded inserts Failure to comply with these requirements, in addition to affecting proper unit operation, invalidates warranty coverage. E/0304/31A/20
Cut-outs for CVC 07 002yy 308 68 172 68 590 92 634 95 150 27 12 261 4 x Ø8 2 x Ø22 42 45 17 24 260 24 E/0304/31A/21
Page 1 and 2: A/C UNITS COMPACT-AIR 230/1/50-60 4
Page 3 and 4: Contents Page Introduction 4 Techni
Page 5 and 6: WHERE AND HOW TO STORE THIS MANUAL
Page 7 and 8: Technical Data CVC 28 002yy - CVC 4
Page 9 and 10: Capacity diagram CVC 14 002 yy (at
Page 11 and 12: Capacity diagram CVC 28 002 yy (at
Page 13 and 14: Dimensions B C A Type CVC 07 CVC 14
Page 15 and 16: 2. Unit Identification This unit ca
Page 17 and 18: Air flow inside the unit Outdoor ap
Page 19: 6. Precautions when handling the Un
Page 23 and 24: Cut-outs for CVC 28 002yy - CVC 41
Page 25 and 26: 10.5 CAPILLARY PIPE EXPANSION SYSTE
Page 27 and 28: 12.6 REGULATING THERMOSTAT The mech
Page 29 and 30: 14. Start-up Supply voltage to the
Page 31 and 32: 18.3 REPLACEMENT OF PARTS To guaran
Page 33 and 34: 20.4 ALUMINIUM CASING - CVCAL With
Page 35 and 36: 21.3.2 TASKS ASSIGNED TO PLANT MANA
Page 37 and 38: · eliminate pressure from the enti
Page 39 and 40: 23. Faults, Probable Causes, Possib

AIR CONDITIONING - Rafstjorn

Create successful ePaper yourself

Delete template?

Save as template?