Nozzle Loads, Piping Stresses, and the Effect of Piping on Equipment

More documents

Recommendations

Info

Typical <strong>Piping</strong> Layout • Try to negate forces <strong>and</strong> moments by supporting <strong>the</strong> pipe at <strong>the</strong> same level as <strong>the</strong> pump. (Equal <strong>the</strong>rmal growth) 16
Typical <strong>Piping</strong> Layout continued… • First piping support before or after a nozzle is always an adjustable base support or a spring – Allows for proper alignment at site, as site conditions never match <strong>the</strong> elevations in model. – Example shown is mounted on an elbow, but <strong>the</strong>se types <strong>of</strong> supports are used on straight runs <strong>of</strong> pipe as well. Typical Adjustable Base Support 17
Page 1 and 2: Nozzle Loa
Page 3 and 4: Introduction • As Mechanical Equi
Page 5 and 6: What are Equipment Nozzle</
Page 7 and 8: The Piping <strong
Page 9 and 10: Stress Engineering Tools • Stress
Page 11 and 12: Max ratio Same layout showing ASME
Page 13 and 14: Piping Support Typ
Page 15: Special Piping Sup
Page 19 and 20: Strut to restrain the</stro
Page 21 and 22: API vs ANSI Pump Design API 610 ANS
Page 23 and 24: API vs. ANSI Nozzle</strong
Page 25 and 26: API vs. ANSI Nozzle</strong
Page 27 and 28: Nozzle Load Issues
Page 29 and 30: High Temperature Barrel Pump • <s
Page 31 and 32: Very low thermal s
Page 33 and 34: Why is piping always bugging me? Co
Page 35 and 36: How can Nozzle <st
Page 37 and 38: Pumps rotated 180 deg. to reduce pi
Page 39 and 40: References • Pumps - API 610 10 t

Nozzle Loads, Piping Stresses, and the Effect of Piping on Equipment

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?