Download IB for MS2310DVB.pdf - Cello

User Help Guide
Should you experience problems, please consult the guide below before calling the
Customer Help line.
SYMPTOM POSSIBLE CAUSE REMEDY
Dead. No LED Lit
Dead. Led lit red
Blue screen.
Noisy, snowy,
ghosting picture
(TV)
No sound.
Bright dot/s on screen
Unstable picture
Unstable picture
GENERAL
Check all connections to the TV including
No power to the TV. the Mains lead and Mains socket
Set still in standby
No signal
Incorrect source
selected
Poor aerial signal
Incorrect sound
system
Sound "Mute"
Volume set too low
External leads not
connected "if used"
Pixel turned on fully.
Press either the Power button or the Standby
button on the Remote control
TV not tuned in. Aerial not connected.
Press TV/AV button to select correct source.
If using an indoor aerial, try moving the
aerial. Check aerial connections
Have an out door aerial fitted.
Check "System" select in "TV Menu" see
page 17.
Turn sound "Mute" OFF
Check volume settings
Check all external leads are connected
Occasionally one or two pixels may fail, this
is normal as the screen ages or suffers a
violent impact. This is not a fault covered by
warranty
PC Monitor
Monitor may not be Enter PC Menu and select "AUTO" see page 15
set to PC correctly.
No connection from Check PC/Monitor connecting lead.
PC.
PC Screen refresh Enter PC Screen setup and set refresh rate
rate is set too high. at 60Hz
-24 -