Caffe Bellissimo - Sunbeam
Caffe Bellissimo - Sunbeam
Caffe Bellissimo - Sunbeam
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Preparing your <strong>Sunbeam</strong><br />
<strong>Caffe</strong> <strong>Bellissimo</strong><br />
Fitting the tray for tall glasses<br />
The tray enables the use of taller glasses.<br />
To fit:<br />
Push the drip tray with the cup grate into<br />
the coffee machine until it snaps into<br />
place.<br />
Lift the front of the coffee machine<br />
slightly, centre and push the tray from the<br />
front under the coffee machine. Lower the<br />
coffe machine and allow the tray to snap<br />
in. Refer to Figure 1.<br />
Remove the lid (b) of the pre-ground coffee<br />
shaft by opening it to an upright position<br />
and turning to the right or left to pull it out<br />
of its holder. Refer to Figure 2.<br />
a<br />
Figure 2<br />
Place the larger coffee bean container on<br />
top of the smaller bean container.<br />
See Figure 3.<br />
Fitting the coffee bean container<br />
It is possible to increase the capacity of the<br />
coffee bean container to 450g.<br />
To increase the coffee bean container size:<br />
Remove the lid (a) of the coffee bean<br />
container by opening it to an upright<br />
position and pulling it out of its holder.<br />
Figure 3<br />
Note: Make sure that the grinder fineness<br />
levers are on top of each other.<br />
Fit the lid (b) of the coffee powder shaft by<br />
inserting it into the holder and turning it<br />
into position.<br />
9
Change language