Design limits and solutions for very large wind turbines

[33] Schlotter M., “A Comparison of Core Materials for
Sandwich Composite Constructions”. June, 2002.
[34] Sundaresan M.J. (NREL), Shulz M.J. (NREL),
Ghoshal A. (NREL), Structural Health Monitoring
Static Test of a Wind Turbine Blade, August 1999.
[35] Teuwen J., ‘Vacuum infused thermoplastic
composites for wind turbine blades’, Presentation
at Wind Turbine Blade Workshop, Sandia
National Laboratories, 12-14 May 2008.
[41] Zingraff L. et al., ‘Resin transfer moulding
of anionically polymerised polyamide 12’,
Composites Part A, Vol. 36, Issue 12,
December 2005, pages 1675-1686.
[42] DS 472. Code of practice for loads and safety of
wind turbine constructions. The Danish Society
of Engineers and the Federation of Engineers.
1992.
[43] Gamesa Structures Manual (FSM).
[36] Tsai S.W.; Hahn, H. T. Introduction to Composite
Materials. Technomic Publishing Company.
Wesport.1980.
[37] Van Rijswijk K., Bersee H.E.N., ‘Reactive
processing of textile fiber-reinforced
thermoplastics – An overview’, Composites:
Part A, 2006.
[38] Van Rijswijk K., Bersee H.E.N., Beukers A.,
Picken S.J., Van Geenen A.A., ‘Optimisation
of anionic polyamide-6 for vacuum infusion
of thermoplastic composites: Influence of
polymerization temperature on matrix properties’,
Polymer Testing, volume 25, 2006, p392-404.
[39] Van Rijswijk K., Bersee H.E.N., Beukers A.,
Picken S.J., Van Geenen A.A., ‘Optimisation of
anionic polyamide-6 for vacuum infusion of
thermoplastic composites: Choice of activator and
initiator’, Composites: Part A, volume 37, 2006,
p949-956.
[40] Verghese K.E., “Durability of Polymer Matrix
Composites for Infrastructure: The Role of the
Interphase”, in Materials Engineering Science.
1999, Virginia Polytechnic Institute and State
University: Blacksburg, VA.
[44] Germanischer Lloyd – Rules and Regulations.
Non Marine Technology. Regulations for the
Certification of Wind Energy Conversions
Systems. 2003.
[45] IEC 61400-1 Ed.3: Wind Turbine Generator
Systems – Part 1: Safety Requirements.
International Electrotechnical Commission.
Mayo, 2005.
[46] IEC 61400-1 Ed.3: Wind turbines - Part 1:
Design requirements. International
Electrotechnical Commission. Mayo, 2005.
[47] IV-1 Guideline Certification Wind Turbines.
Ed. 2003, sup. 2004. Germanischer Lloyd Wind
Energie. 2004.
[48] TPI Composites, Inc. “Innovative Design
Approaches for Large Wind Turbine Blades Final
Report: WindPACT Blade System Design Studies”
Sandia National Laboratories: Albuquerque, NM.
SAND 2004-0074, Mayo 2004.
Design limits and solutions for very large wind turbines
43