AIR GREASE GUN - Harbor Freight Tools

More documents

Recommendations

Info

4. Carefully, reassemble the Container Tube (17) to the top on the Housing Cap (7). Press the Catch Plate (20) and release the Plunger Handle (19). Press the Plunger Handle (19) in as far as it will go. Butterfly Lock Knob (25) Front Housing (7) Adapter (8) Air Fitting (2) Finger Grip (1) Flexible Hose Assy. (29) Trigger (3) Bend Spout (9) Plunger Handle (19) FIGURE A Container Tube (18) Follower Rod (18) FIGURE B FIGURE C Top view of Container Tub (17) Catch Plate (20) Air Vent Valve (10) Filler Plug (28) Plunger Handle (19) REV 07/05 SKU 94322 For technical questions, please call 1-800-444-3353. Page 6
Loading with a Filler Pump (not included) See the Assembly Drawing on page 9, Figures A, B, and C on page 6 and FIGURE 1 on page 5. 1. Slowly, pull back and fully extend the Handle (21). Lock it into place with the Locking Plate (20). 2. Insert the Filler Plug on the end of the hose of the Filler Pump (not included) into the Nozzle (10). 3. Follow the instructions provided in the Filler Pump manual (not included) to operate the Filler Pump until the Tube (18) is full. 4. Disconnect the Grease Gun from the Filler Pump (not included). 5. Press the Locking Plate (20) and release the Handle (21). Press the Handle (21) in as far as it will go. How to Rotate the Finger Grip Note: If your application requires you to rotate the Finger Grip (1), loosen the Butterfly Lock Plug (25) Twist the Housing (22) to the desired angle then tighten the Butterfly Lock Plug (25) (see Figure A, page 6). Operating the Grease Gun Note: If your application requires the Flexible Hose (29), attach it to the Bent Spout (9). Before every use, prime the Grease Gun by operating the Gun (see below) until grease flows from the tip. If it does not prime properly, follow the directions above for venting trapped air. 1. Attach the Grease Gun to the air source hose following the directions on page four. Set the air compressor to 30 - 100 PSI. 2. Squeeze the Trigger (3) to begin the flow of grease. 3. Release the Trigger (3) to stop the flow of Grease. 4. Disconnect from the air source hose before refilling the Grease Gun. Turn off the air compressor. Warning! The Grease Gun may still have air pressure after disconnected from the air source. Point the Grease Gun into a suitable receptacle and fire it until all of the air is expended. Note: Before every use, prime the Grease Gun by operating the Gun (see above) until grease flows from the tip. If it does not prime properly, follow the directions above for venting trapped air. SKU 94322 For technical questions, please call 1-800-444-3353. Page 7
Page 1 and 2: AIR GREASE GUN Model 94322 ASSEMBLY
Page 3 and 4: 7. Use eye and ear protection. Alwa
Page 5: Grease Loading Instructions Grease
Page 9 and 10: SKU 94322 For technical questions,

AIR GREASE GUN - Harbor Freight Tools

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?