STOVE GUIDE - DanSkan

i-AIR
FULLY AUTOMATIC INNOVATION
A MODERN LINE FEATURE
All DAN SKAN Modern Line stoves feature the innovative fully automatic
i-Air system where the entire combustion process is independently and
automatically regulated from the pre-fire start to the dying embers at the
fire‘s end without the need for electricity.
As on the original Classic Line stoves, the heart of the automatic
system remains the proven and DAN SKAN patented bimetal spring control
which now regulates primary, secondary and tertiary air to maximise
the stove‘s overall efficiency.
WHY AUTOMATIC?
Maximising highly efficient and environmentally friendly combustion
requires constant adjustments to the flow and levels of combustion air
– primary, secondary and tertiary, throughout the burn cycle. This would
be virtually impossible to achieve, even for a stove expert, as you would
need to constantly monitor the flame colour and character then regulate
the air accordingly – a time-consuming process! Only a test laboratory
could come close and only with the use of technically sophisticated
equipment.
When starting a fire a large amount of oxygen is needed to ignite the
combustible material as quickly as possible, which then needs to be
reduced to control the burn rate of the fuel so that it is not wasted – but not
too much so that nuisance smoke and soot is created if the fuel is starved
of combustion air. Good regulation of the correct combustion air can
really only be achieved by using an intelligent automatic system which
will consistently supply the fire with the necessary air: DAN SKAN i-AIR!
TOTAL CONTROL
i-Air automatically regulates the air supply throughout the entire burning
process to get the best performance out of your fuel and stove so that
you don‘t have to. You can sit back and relax knowing that even the best
test results achieved in the laboratory are now easily achievable in the
home, maximising fuel efficiency and minimising the effects on the
environment.
MAXIMUM EFFICIENCY
i-Air is a cost-effective energy-efficient combustion process that not only
protects the environment but can also save you money.
DAN SKAN‘s patented i-Air automatic system has been proven to extend
the fuel burn time and reduce emissions by controlling the fire chamber
temperature, which in turn results in lower heat losses.
Secondary air
Tertiary air
ENVIRONMENT
PROTECTION
Combustion curve without i-Air
Combustion curve with i-Air
CO 2
emission without i-Air
CO 2
emission with i-Air
Primary air
300° C
0,3% CO2
73