Rider's Manual K 1200 R - K100.biz
Rider's Manual K 1200 R - K100.biz
Rider's Manual K 1200 R - K100.biz
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
z Operation<br />
Oil level<br />
The readings mean:<br />
OK: Oil level is correct.<br />
CHECK: Check the oil level the<br />
next time you stop for fuel.<br />
---: Oil level cannot be measured<br />
(conditions as stated above<br />
not satisfied).<br />
Tyre pressure<br />
monitoring RDC OE<br />
Viewing tyre-pressure<br />
readings<br />
Switch on the ignition.<br />
4<br />
53<br />
Oil-level indicator 1 gives you<br />
an indication of the engine oil<br />
level. You can call up this reading<br />
only when the motorcycle is<br />
at a standstill.<br />
The preconditions for the oil level<br />
check are as follows:<br />
Engine at operating temperature.<br />
Engine idling for at least 10<br />
seconds.<br />
Side stand retracted.<br />
Make sure the motorcycle is<br />
upright.<br />
If you call up another reading<br />
on the on-board computer,<br />
this symbol remains visible<br />
until the sensor again registers a<br />
correct oil level.<br />
The most recently measured<br />
level is displayed for 5 seconds<br />
when you next switch on the ignition.<br />
The oil sensor might be<br />
defective if the "Check oil<br />
level" message reappears even<br />
though the oil level shown by the<br />
oil tank's level indicator is correct.<br />
In this case, consult your authorised<br />
BMW Motorrad dealer.<br />
Repeatedly press button 1 until<br />
the tyre pressures appear on<br />
the display.
Change language