Rider's Manual K 1200 R - K100.biz

z Riding
with OE Automatic Stability
Control (ASC):
Switch on the ignition.
Pre-ride check is performed.
( 73)
ABS self-diagnosis is
performed. ( 74)
ASC self-diagnosis is performed.
( 74)
Press starter button 1.
If ambient temperatures are
very low, you might find it
necessary to open the throttle
slightly when starting the engine.
At ambient temperatures below
0 °C, disengage the clutch after
switching on the ignition.
The start attempt is automatically
interrupted if battery
voltage is too low. Recharge
the battery before you start the
engine, or use jump leads and a
donor battery to start.
The engine starts.
Consult the troubleshooting
chart below if the engine refuses
to start. ( 136)
Pre-ride check
The instrument cluster runs a
test of the 'General' warning light
when the ignition is switched
on: this is the "Pre-Ride-Check"
The warning light shows first red
and then yellow, so that you can
check that it is in working order.
The test is aborted if you start
the engine before it completes.
Phase 1
General warning light shows
red.
CHECK! appears on the display.
Phase 2
General warning light shows
yellow.
CHECK! appears on the display.
If the 'General' warning light does
not show:
Some malfunctions cannot
be indicated if the 'General'
warning light cannot be displayed.
Check that the 'General' warning
light comes on, and that it shows
red and yellow.
Have the fault rectified as
quickly as possible by a
specialist workshop, preferably
5
73