Rider's Manual K 1200 R - K100.biz

4
54
Lights
Side light
The side lights switch on automatically
when the ignition is
switched on.
High-beam headlight
z Operation
The tyre pressures are shown,
accompanied by the wording
RDC P. The front tyre pressure
is on the left; the reading on the
right is the rear tyre pressure.
-- -- appears directly after the
ignition is switched on, because
the sensors do not transmit tyre
pressures until the motorcycle
accelerates to 30 km/h.
The readings alternate with the
clock.
If the motorcycle has an onboard
computer the readings alternate
with the clock and the
values of the on-board computer.
The side lights place
a strain on the battery.
Do not switch the ignition
on for longer than absolutely
necessary.
Low-beam headlight
The low-beam headlight switches
on automatically when you start
the engine.
When the engine is not
running you can switch on
the lights by switching on the ignition
and either switching on the
high-beam headlight or operating
the headlight flasher.
Press the top section of fullbeam
headlight switch 1.
High-beam headlight switched
on.
Move full-beam headlight
switch 1 to the centre position.
High-beam headlight switched
off.
Press the bottom section of
full-beam headlight switch 1.
The high-beam headlight is
switched on until you release
the button (headlight flasher).