Owners Manual - Moomba

Troubleshooting
INSTRUMENT DOES NOT TURN ON (continued)
housing or replace the fuse holder assembly if
necessary.
2. Check the power cable connection. Be sure that the
unit is connected to a known power source:
RED wire to positive, BLACK wire to negative or
ground.
Out of Range Display
If the display indicates three horizontal bars as shown,
the depth sounder indicates an out of range, inaccurate or
incomplete data condition.
An out of range condition occurs when the depth reading
is less than 2.5 feet (3.0 Meters) or greater than 200 feet
(60.9 Meters).
Inaccurate or incomplete data will cause an out of range
condition when operating in extremely dirty water, very
soft bottom or at high speeds. A faulty or improper
transducer connection can also cause an out of range error
condition.
Troubleshooting
INSTRUMENT DOES NOT TURN ON
3. Ensure that the power source is powered using a
test light or some other reliable form of testing 12 volt
power.
4. If you are sure that the unit is receiving power and is
still not functioning, please contact Customer Service
for assistance.
RANDOM OR FLASHING BOTTOM READING
1. Under certain circumstances, the depth sounder may
not perform at the best of its ability. Extremely dirty
water, very soft bottom, high speeds, deep water, or a
combination of the above will result in incomplete or
inaccurate readings.
2. Check the transducer cable connection on the back of
the unit.
3. Contact Customer Service for assistance if you are
unable to correct the problem.
1. If applicable, check main power supply fuse to the unit.
If it is blown, replace it with a 1 amp, normal blow fuse.
If in-line fuse is used, clean all corrosion from the fuse
© 2008 Skier’s Choice, Inc.
33