Motors - TEA Machine Components Inc.

MOTOREN
NECKAR
Electronically commutated
MH 5...8 with integrated 1Q-Controller
Terminal lead designation with terminal box K4 standard:
External wiring
*1 Rotating right
*2 Brake active
*3 No release
Attention!
Maximum connection voltage 26,5 V!
Coded switch positions for internal operation:
J1 Rotation direction: ON = Rotating left
J2 Brake:
ON = Short circuit brake inactive
J3 Release:
ON = Motor released
J4 Int./Ext.-Set-point: ON = Internal set-point assignment
J5 Ramp:
ON = Set-point ramp inactive
For external function selection plug corresponding
bridges on the following positions –
otherwise danger of short circuit!
J1 Rotation direction:
J2 Brake:
J3 Release:
J4 Int./ext. Set-point:
OFF – Position
OFF – Position
OFF – Position
OFF – Position = External set-point
OFF – Position = assignment
+VC: 24VDC +10/– 6 %
Gnd: Supply earth
Rev: Rotation reversal (High level 12..24V = Rotating left)
Brake: Short circuit brake (High level 12..24V = Brake inactive)
Enab.: Motor release (High level 12..24V = Function)
S +: Set-point + (12V)
S: Set-point input (0..10V)
S –: Set-point earth
Erro: Fault signal output (Open collector max. 45V 300mW)
RI-A: Impulse output A-Spur (Open collector max. 45V 300mW) 2 Impulse/min –1
RI-B: Impulse output B-Spur (Open collector max. 45V 300mW) 2 Impulse/min –1 120° Phase displacement
D1: Ready for operation indicator
D2: Fault / Excess current indicator
Control range 30:1
Speed range 100 – 3000 min –1
Note:
– The respective functions or operating elements should be reserved either only externally or internally as otherwise this can result
in incorrect functions.
– For internal set-point assignment the trimmer P2 is used for adjusting the speed.
– For external set-point assignment the trimmer P2 is used for adjusting the maximum speed (set-point adjustment).
– Trimmer P1 with an active ramp is used for adjusting the starting time.
24 ■