Probes for Coordinate Measuring Machines - Mitutoyo America ...

TP2-5W
Compact Touch Trigger Probe
• Compact touch trigger probes
This touch trigger probe has an outside diameter as small as ø13 mm, which greatly
contributes to probing complex portions of a workpiece. With the combined use of an
appropriate probe extension it can probe even deeper locations.
• Enhancing the setup and measurement efficiency through the automatic
change of probe orientation
Since the TP2-5W can be mounted on a probe head such as the PH10M/PH10MQ that
automatically changes the probe orientation, it can drastically reduce the time required to
prepare for measurement and for actual measurement in comparison to a conventionaltype
scanning probe that has a fixed position downward. With the combined use of an
appropriate probe extension it can probe even deeper locations (when it is mounted on
the CNC coordinate measuring machine).
TP2-5W Specifications
TP2-5W
Measuring direction
Repeatability (2 )
Directionality (XY: 2D)
Directionality (XYZ: 3D)
Required force to generate
trigger signal
Amount of over-travel
Required force to achieve
over-travel
Stylus mounting method
Mass of single unit
Durability
Probe head
Applicable models
XY
Z
XY
Z
XY
Z
±X, ±Y, +Z
0.35µm or less
±0.8µm (with 10mm stylus), ±2.5µm (with the 50mm stylus)
±1µm (with 10mm stylus), ±4µm (with the 50mm stylus)
0.07 to 0.15N (Variable. Standard: 0.07N)
0.7N (when the X and Y axis are set to standard)
XY±14º, Z+4mm (when the required force to generate trigger signal is 0.07N)
±4mm (when the required force to generate trigger signal is 0.07N), +3mm (at 0.15N)
0.2 to 0.4N
4N (when the required force to generate trigger signal is 0.07N)
M2 screw
22g
1,000,000 times
Essential: PH10M/PH10MQ/MIH/PH1
Manual/CNC coordinate measuring machines
20