Competition Tachs & Gauges - KNS Autosport
Competition Tachs & Gauges - KNS Autosport
Competition Tachs & Gauges - KNS Autosport
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Speedometers<br />
SPEEDOMETERS<br />
GENERAL:<br />
Speedometers indicate vehicle speed along with providing total mileage and often a<br />
trip mileage reading.<br />
NOTE: Check your local laws/regulations to determine how to properly document<br />
mileage when a speedometer is replaced.<br />
CAN BE USED ON:<br />
Most applications where vehicle speed is desired. Note: in the USA, speedometers<br />
are required for all motor vehicles used on public roadways, consult local laws for<br />
any exceptions.<br />
GOOD FOR:<br />
Accurate speed indication after modifications have been made such as wheel size or<br />
gearing.<br />
WHAT YOU NEED TO KNOW:<br />
Does your vehicle already have an electric sender or are you replacing a mechanical<br />
speedometer. If your system does not already have<br />
an electric sender, a sender can be installed where the<br />
mechanical cable was previously connected.<br />
Stewart Warner does have mechanical speedometers<br />
available that take their signal from the mechanical cable<br />
connected to the transmission.<br />
You can find this gauge in the following<br />
product lines:<br />
Line<br />
<strong>Competition</strong> <strong>Tachs</strong> & <strong>Gauges</strong> 10<br />
Deluxe 24<br />
Wings 32<br />
Power Series 36<br />
Page<br />
Heavy Duty 42<br />
12V IGNITION SWITCH<br />
WHAT YOU SEE:<br />
Speed indication and odometer reading.<br />
The <strong>Competition</strong> <strong>Tachs</strong> & <strong>Gauges</strong> line speedometers also<br />
provide two trip meters. The trip meters are accessed<br />
using the included calibration/reset switch which can be<br />
mounted where desired.<br />
HOW IT WORKS:<br />
ELECTRIC<br />
The Stewart Warner electric speedometer is connected to<br />
a speed sensor via wires. The electric<br />
speedometers can be calibrated &<br />
recalibrated as needed after gearing<br />
or tire size changes by driving a<br />
specified distance and<br />
1) <strong>Competition</strong> <strong>Tachs</strong> & <strong>Gauges</strong><br />
- use the reset button to set calibration<br />
2) On other Stewart Warner<br />
electric speedometers - set the dip<br />
switches on<br />
the rear of the unit per the installation<br />
instructions<br />
MECHANICAL<br />
Mechanical speedometers are connected<br />
via cable to the transmission<br />
speed take-off. If you require a new<br />
cable contact us to find a distributor<br />
near you that makes these cables.<br />
NOTE: If your vehicle currently has<br />
a mechanical speedometer, you can<br />
convert to an electric speedometer<br />
by connecting a one of Stewart Warners<br />
speed sensors to the speedometer<br />
connection on the transmission.<br />
106 1-800-676-1837 Or 1-866-797-7223