FlashRunner FR01ENG User's Manual - Ahlers EDV Systeme GmbH
FlashRunner FR01ENG User's Manual - Ahlers EDV Systeme GmbH
FlashRunner FR01ENG User's Manual - Ahlers EDV Systeme GmbH
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>FlashRunner</strong> <strong>FR01ENG</strong> <strong>User's</strong> <strong>Manual</strong><br />
• Routes control signals (START, STOP, BUSY, PASS, FAIL and script<br />
selection lines) to your test/programming equipment (only necessary for<br />
standalone operations).<br />
Connections between the carrier board and the target board typically consist<br />
of flat cables that plug into the ISP connector on the target board(s) or single<br />
wires that connect to the single nails of your bed-of-nails fixture.<br />
The figure below illustrates typical programming connections.<br />
2<br />
Carrier Board<br />
“CONTROL” Connector<br />
“POWER” Connector<br />
“ISP” Connector<br />
To Target Board<br />
Figure 2.1: Typical Programming Connections<br />
The specific ISP signals that must be routed from <strong>FlashRunner</strong> <strong>FR01ENG</strong> to<br />
your target board depend on the specific target device. Typical connections<br />
for all the device families supported by <strong>FlashRunner</strong> are shown in the<br />
<strong>FlashRunner</strong> Programmer’s <strong>Manual</strong>.<br />
19