Electrode Steam Humidifier Manual

Note: Please contact HygroMatik if you wish to operate the unit
with softened water.
• If using a water softening system, we recommend diluting
the softened water with normal tap water to produce
an overall hardness between 4-8°dH.
• When feed water contains softened water, the level of
conductivity is typically higher at operating temperature.
Install a HygroMatik "cylinder star" to extend the service
life of the electrodes.
6.2 Water Supply
» Install a shut-off valve (SV) in the supply line.
» Install a water filter (WF) if water quality requires it.
Note: Shut-off valve (SV) and water filter (WF) are not supplied
with the unit
» HygroMatik provides a water hose (56) with a cap nut at
both ends which can be used for water installation.
Install as follows:
» Screw and tighten the cap nut with its inner seal ring
around the water supply screw connection that protrudes
from the base.
Note: Tightening too much will destroy the fitting. The valve
strainer (29) must be placed inside the solenoid valve.
» Use a cap nut (internal thread ¾“) with inner seal for a
customer-provided water installation.
Page 19