Electrode Steam Humidifier Manual

More documents

Recommendations

Info

» Place solenoid valve with seal in the borehole of the unit housing. » Attach solenoid valve tightly with screws (28). » Screw on water installation hose. » Connect e-cable to the solenoid valve. » Attach connecting hose (21) to the base. » Install cylinder, as described in Section: "Removing and Cleaning the <strong>Steam</strong> Cylinder” » Turn on the tap. » Switch on the unit and check for leaks during operation. If leakage occurs, switch off power supply and follow safety instructions for work on live components. 9.8 Checking Cable Connections and <strong>Electrode</strong> Cables » Make sure that no cable and plug connections are loose. Warning: Plugs must be pressed down onto electrodes as far as they will go. Loose cable connections cause excessive contact resistance and overheating of contact surfaces. » Check electrode plug isolation, replace plugs as needed. Warning: Replace electrode plugs after removing and reinstalling them several times. 9.9 Checking Operation Start up the unit and operate for a few minutes at maximum output if possible. » Check safety devices. » Check hose connections for possible leaks. 9.10 Dismantling After you stop using the steam humidifier, dismantle (demolish or scrap) it by following the installation procedures in reverse order. Warning: Dismantling of the unit is only to be attempted by qualified personnel. Electrical dismantling is only to be attempted by trained professionals. Note the information provided in Section 2 "Safety Notes," especially the guidelines for disposal. Page 38
10. EC-Decleration of Conformity Page 39
Page 1 and 2: Manual Electrode Steam Humidifier M
Page 3 and 4: 1. Introduction ...................
Page 5 and 6: 1. Introduction Dear Customer, Than
Page 7 and 8: 2. Safety Notes 2.1 Overview These
Page 9 and 10: 3. Transport 3.1 Overview Note: Pro
Page 11 and 12: 4. Operation and Installation 4.1 M
Page 13 and 14: The concentration of dissolved salt
Page 15 and 16: 5.1.1 Fitting measures Wall Distanc
Page 17 and 18: 5.3 Unit Dimensions Page 17
Page 19 and 20: Note: Please contact HygroMatik if
Page 21 and 22: 6.4 Water Installation Check Go dow
Page 23 and 24: Free Drain of Discharged Water Drai
Page 25 and 26: HyLine: Type HY05 - HY45 HY60 - HY1
Page 27 and 28: 7.2 Safety Interlock Note: Install
Page 29 and 30: 9. Maintenance The HygroMatik steam
Page 31 and 32: 9.3 Removing and Cleaning the Steam
Page 33 and 34: Reassembly » Connect plug (10) to
Page 35 and 36: 9.4.2 Uneven Electrode Lengths In m
Page 37: 9.6 Cleaning the Blow- Down Pump »
Page 41 and 42: * MS5 MS10 Article no. Description
Page 43 and 44: 13. Technical Data Technical Data S
Page 45 and 46: 15. View of housing Page 45

Electrode Steam Humidifier Manual

Create successful ePaper yourself

Delete template?

Save as template?