Electrode Steam Humidifier Manual

» Place solenoid valve with seal in the borehole of the
unit housing.
» Attach solenoid valve tightly with screws (28).
» Screw on water installation hose.
» Connect e-cable to the solenoid valve.
» Attach connecting hose (21) to the base.
» Install cylinder, as described in Section: "Removing
and Cleaning the Steam Cylinder”
» Turn on the tap.
» Switch on the unit and check for leaks during operation.
If leakage occurs, switch off power supply and follow safety
instructions for work on live components.
9.8 Checking Cable Connections and Electrode
Cables
» Make sure that no cable and plug connections are
loose.
Warning: Plugs must be pressed down onto electrodes as far
as they will go.
Loose cable connections cause excessive contact resistance
and overheating of contact surfaces.
» Check electrode plug isolation, replace plugs as
needed.
Warning: Replace electrode plugs after removing and reinstalling
them several times.
9.9 Checking Operation
Start up the unit and operate for a few minutes at maximum output
if possible.
» Check safety devices.
» Check hose connections for possible leaks.
9.10 Dismantling
After you stop using the steam humidifier, dismantle (demolish
or scrap) it by following the installation procedures in reverse
order.
Warning: Dismantling of the unit is only to be attempted by qualified
personnel. Electrical dismantling is only to be attempted by
trained professionals.
Note the information provided in Section 2 "Safety Notes," especially
the guidelines for disposal.
Page 38