Electrode Steam Humidifier Manual

Cycle
4 Weeks after
initial operation
(with normal
water quality)
Semiannually
(with normal
water quality and
"normal" operation
= 8h/Day)
Maintenance Work
Visual inspection of electrical and
mechanical connections
Remove mineral deposits from steam cylinder,
water drain hose and blow-down
pump
Check electrodes for erosion
Visual inspection of electrical and
mechanical connections
Remove mineral deposits from steam cylinder,
water drain hose and blow-down
pump
und ggf. erneuern.Check electrodes for
erosion
In most cases, the conductivity levels given in Section 1.1
"Directions for Use" of these instructions can be considered normal.
Individual parameter setting of the control may be necessary.
In extreme cases, water pretreatment may be necessary (softening
by dilution to approx. 4 - 8 °dH; decarbonization/partial
desalination to achieve target reductions in carbonate hardness).
HygroMatik would be pleased to refer you to companies specializing
in water treatment systems.
9.2 Access Electrical Enclosure
» Remove cover from humidifier (B) and lift display plate
(A) of guiding.
» Turn display plate (please see sketch) and hang up display
plate by using the „front guiding“.
» The basic PCB (C) is now accessable.
Danger, Hazardous Voltage: Make sure the unit is switched off
before installing or removing the display plate.
Page 30