Quick Setup Guide M300 FLOW Transmitter - METTLER TOLEDO

5 Quick Setup (PATH: Menu/Quick Setup)
Quick Setup allows limited configuration of the most common functions of the M300 Flow transmitter.
Detailed information for each function can be found in the individual sections of the manual.
Enter Quick Setup mode
While in Measurement mode press
Setup and press the [ENTER] key.
75.5 GPM
283.9 L/min
MENU
Quick Setup
to bring up the Menu selection. Select Quick
Note: To exit Quick Setup mode at any time press the and keys simultaneously
(Escape). The transmitter returns to the Measurement mode and the old values
remain active.
Flow Sensor Type Selection
Refer to Section 4 for Flow sensor type information.
75.5 GPM
283.9 L/min
SensorType Input High
Measurement Selection
75.5 GPM
283.9 L/min
a GPM
Analog Output? Yes
Select the desired flow sensor type which corresponds to the type of flow sensor wired
to the transmitter. The choices are High, Low and Type 2.
Select the desired line (a or c) to configure the values to be displayed and whether this
value will have an Analog Output.
Convention:
1st line on display = > a
3rd line on display = > c
75.5 GPM
0.000 Gals
Example:
– By selecting a and GPM as units, the flow rate value will be displayed on the 1st line.
– By selecting c and Gals as units, the total flow value will be displayed on the 3rd line
of the display which has more digits of resolution.
– Selecting None means the display will be blank for the line selected.
8