SSETI Express SSETI Express Integration Logbook - Space.aau.dk

Project: SSETI Express
Doc : SSETI Ex press Phase D – Integration Logbook
Phase : Phase D
Date : Started 5 th October 2004
Ref : EXPRESS_D_ESA_Integration_Logbook.doc
6. Only LINT FREE tissues allowed inside the cleanroom (provided)
7. Carry equipment as you enter the cleanroom in the usual manner
Cleaning aluminium boxes and parts
1. Disassemble parts are far as possible
2. Wear gloves
3. Use wire wool (see ESA_Jason) to scrub surfaces, in ONE direction only, under
running warm water (sink outside cleanroom)
4. Dry parts thoroughly
5. Clean thoroughly with IPA tissues
6. Store on tissues in cleanroom
Alternatively: Instead of steps 3,4,5 use the ultrasound bath, however, note that it is small,
and dangerous to put hand in when it is in operation (and not too good when not in operation).
Cleaning honeycomb panels for insert potting
1. Wear gloves to avoid additional fingerprints
2. Remove panels from packaging and place on soft, clean surface (like cardboard)
3. Wipe all dust and debris off of panels with a dry cloth, taking care to maintain a clean
working surface
4. Run the nozzle of a working vacuum cleaner along the exposed core at the sides of
each panel, taking care not to make contact. A good way to do this is to have a piece
of cardboard beneath the panel and protruding slightly, you can then run the nozzle
along the cardboard while lightly holding the panel and cardboard in place
11