SSETI Express SSETI Express Integration Logbook - Space.aau.dk

Project: SSETI Express
Doc : SSETI Ex press Phase D – Integration Logbook
Phase : Phase D
Date : Started 5 th October 2004
Ref : EXPRESS_D_ESA_Integration_Logbook.doc
x. Replace the sun sensor protective cover.
12) Integrate solar panel 8 to the +y lateral panel. Use only those bolt holes that do
not also interface with the primary structure. Do not tighten the bolts fully.
13) Integrate the +y lateral panel to the primary structure and to both the +y corner
profiles. Do not tighten the bolts fully.
14) Integrate solar panel 7 to the +y lateral panel and the primary structure.
15) Tighten all the bolts on the +y lateral panel.
16) Tighten all the bolts on the +x and –x sides of the +y corner profiles.
17) Locate the coil driver correctly on the inside of the –y lateral panel, place M3
bolts through the fixation holes and tape the heads in place so that they will not
fall when the panel is turned.
18) Turn the –y lateral panel over and carefully place solar panel 2 over the coil
driver fixation bolts. Add nuts to these bolts to hold them in place. The
kapton on the reverse side can then be removed.
19) Integrate solar panel 2 to the –y lateral panel. Use only those bolt holes that do
not also interface with the primary structure. Do not tighten the bolts fully.
20) Integrate solar panel 3 to the –y lateral panel and the –y+x corner profile. Use
only those bolt holes that do not also interface with the primary structure. Do
not tighten the bolts fully.
21) Integrate the –y sun sensor to the –y lateral panel. For this, repeat the
instructions given in step 11 above (replacing +y with –y and solar panel 6
with solar panel 3 throughout).
37