SSETI Express SSETI Express Integration Logbook - Space.aau.dk

Project: SSETI Express
Doc : SSETI Ex press Phase D – Integration Logbook
Phase : Phase D
Date : Started 5 th October 2004
Ref : EXPRESS_D_ESA_Integration_Logbook.doc
Prepare the string
- write down the string number, cell class and panel number
- Check that the solders have been verified with a binocular and visually check the
solders again
- position it so that the glass faces the table
- clean the back of the string with an alcohol tissue
Lay the kapton down on the aluminium panel
- tape one strip of LTT on the table
- align the panel next to it
- tape the start of the kapton tape to the LTT
- while the first operator holds the kapton tape aligned over the panel, the second
operator tapes the kapton to the panel inch by inch using a dry tissue and checking for
the presence of air bubbles
- if there is no air bubble at all between the kapton and the panel, the procedure is
reiterated for the next kapton strip. Two adjacent strips must overlap by approximately
3mm. The panel must be completely covered with kapton tape
- cut out the surplus of kapton with a scalpel
25