satellite antenna positioner satellite antenna positioner - Dish TV ...

SATELLITE ANTENNA
POSITIONER
PROFES SIONAL MANUFACTURER & SUPER Q UALITY

MANUAL
SAFETY GUIDE
FRONT PANEL.
REAR PANEL
REMOTE CONTROL
OPERATION
TROUBLE SHOOTING
TECHNICAL INDEX.

SAFETY INSTRUCTIONS & SUMMARIZATION
WARNING
SAFETY INSTRUCTIONS
SUMMARIZATION

FRONT PANEL
FRONT PANEL
FRONT PANEL
East indicator (red)
West indicator (green)
Display panel
Remote receive sensor
Power standby on / off button
Manual control buttons
3 4

REAR PANEL
REAR PANEL
Description of Wiring Terminals :
AC
Connectors
Motor1 / Motor2:
Sensor:
GND
NOTE:
sensor/GND
Sensor/GND Motor 1 / Motor 2
Motor1
Motor2

REMOTE CONTROL
REMOTE CONTROL
POWER Standby on/off :
0-9 Numeric keys :
Resync :
Store :
Clear :
ESC:
3 or 4 Manual keys:
OK:
P+ or P- :
NOTE:

SETTING ANTENNA TRAVEL LIMIT & STORE SATELLITE POSITION
SETTING ANTENNA TRAVEL LIMIT
NOTE: If you operate this product for first time, antenna travel limit must be set up,
Please follow the steps:
A. Turn on the unit :
B. Set the east borders :
3
C. Set the west borders :
4
STORE SATELLITE POSITION
3 4

RECALL SAVED SATELLITE POSITION
OK
NOTE:
RECALL SAVED SATELLITE POSITION
OK
P+ P-
OK
NOTE:

RESYNCHRONIZATION SATELLITE POSITION & CLEAR ONE SATELLITE FROM MEMORY
RESYNCHRONIZATION SATELLITE POSITION
3 4
NOTE:
CLEAR ONE SATELLITE FROM MEMORY
NOTE:
SETTING ANTENNA TRAVEL LIMIT

STARTING OPERATION & MOVE THE ANTENNA
STARTING OPERATION
3 4
MOVE THE ANTENNA
3 4
3 4
NOTE:

TROUBLE SHOOTING
TROUBLE SHOOTING
Problem Cause and/or remedy
You can't locate the satellite after
completing the installation
nP shown on the display.
(nP:no pulse)
1. The display is blank.
1-1 Please check the positioner
plug for looseness.
1-2 Please make sure the outlet
with electricity.
2. The display(dot)is on and without
nP shown on the display.
2-1 Please check whether the
batteries are put into the
remote controller or not.
2-2 Please check whether the
batteries are out of electricity
or not. If you have made the
corrections above and can't
solve the problem, please call
your installer or dealer.
1. Make sure all the necessary wiring
is commected correctly and firmly.
2. If the nP is still shown on
the display after you've checked
the wiring.The possible causes
could be from the motorized system
(actuator, sensor) or the antenna
itself.
3. Please check with your installer
or dealer.

TROUBLE SHOOTING
TROUBLESHOOTING
Problem Cause and/or remedy
The TV picture is ambiguous or
no display appears when you
move the antenna to your stored
satellite position.
POSITION
STORE SATELLITE
SATELLITE POSITION
RESYNCHRONIAZTION
3 4
Any problems that are not listed.
Call and check with the dealer.

SPECIFIC ATIONS & PRODUCT ASSORT REFERENCED ANTENNA TYPE
SPECIFICATIONS
Main Voltage
Power Consumption
Dimensions
Weight
Wiring Terminals:
Motor Voltage
Sensor Voltage
Sensor Type:
Remote Control:
Function key
Battery
Specifications are subject to change without notice.