P.00-15 - Outlander-Forum
P.00-15 - Outlander-Forum
P.00-15 - Outlander-Forum
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
GENERAL <br />
PRECAUTIONS BEFORE SERVICE<br />
00-31<br />
Data link<br />
connector<br />
MB991910<br />
MB991824<br />
MB991827<br />
ZC501967<br />
AC404789<br />
ZC5019680000<br />
Connect scan tool MB991958 to the 16-pin data link connector<br />
as follows.<br />
NOTE: For details on how to use scan tool MB991958, refer<br />
to the "M.U.T.-III Owner's Manual."<br />
1.Ensure that the ignition switch is at the "LOCK" (OFF) position.<br />
2.Start up the personal computer.<br />
3.Connect special tool MB991827 to special tool MB991824 and<br />
the personal computer.<br />
4.Connect special tool MB991910 to the special tool MB991824.<br />
5.Connect special tool MB991910 to the data link connector of<br />
the vehicle.<br />
6.Turn the special tool MB991824 power switch to the "ON"<br />
position.<br />
NOTE: When the special tool MB991824 is energized, the<br />
special tool MB991824 indicator light will be illuminated<br />
in a green color.<br />
7.Turn the ignition switch to the "ON" position.<br />
8.Select "Special Function" form the menu screen.<br />
9.Select "Learned Value Reset" form the menu screen.<br />
10.Initialize the learning value.<br />
11.After initialization of the learning value, learn the idling in MFI<br />
engine. (Refer to LEARNING PROCEDURE FOR IDLING IN<br />
MFI ENGINE <strong>P.00</strong>-31).<br />
ENGINE IDLING LEARNING PROCEDURE<br />
M10001000118USA0000010000<br />
PURPOSE<br />
When the ECM is replaced, or when the learned value is<br />
initialized, the idle may not be stabilized. Carry out the learning<br />
method by following the procedures below.<br />
LEARNING PROCEDURE<br />
1.Start the engine and warm to reach 80°C (176°F) or more.<br />
NOTE: When the engine coolant temperature is 80°C (176°<br />
F) or more, the warm-up is not needed if the ignition<br />
switch is in "ON" position once.<br />
2.Turn the ignition switch to "LOCK" (OFF) position.<br />
3.After 10 seconds or more, start the engine again.<br />
4.For 10 minutes, carry out the idling under the condition shown<br />
below and then confirm the engine has the normal idling.<br />
⦆Transaxle: P range<br />
⦆Operation in ignition-related, fan and attachments: Not to be<br />
operated<br />
⦆Engine coolant temperature: 80°C (176°F) or more<br />
NOTE: If the engine stalls while idling, check for a<br />
dirty (on the throttle valve) of the throttle body and