P.00-15 - Outlander-Forum
P.00-15 - Outlander-Forum
P.00-15 - Outlander-Forum
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
00-40<br />
GENERAL <br />
PRECAUTIONS BEFORE SERVICE<br />
Item name<br />
Condition tone alarm<br />
Rent-a-car mode always IG-OFF<br />
Rent-a-car mode door open IG-OFF<br />
Initial value<br />
Available<br />
Available<br />
Available<br />
Service reminder schedule table NAS 10<br />
ACD control display<br />
TPMS information<br />
Horn chirp by RKE<br />
Rear S/R unlock output<br />
Trailer turn detection<br />
Lever<br />
AFS<br />
SATR<br />
Fuel tank type<br />
KOS auto lock customize<br />
DRL function<br />
FACU<br />
S AWC control display<br />
Diesel particulate filter<br />
Language mode<br />
WSS<br />
Not available<br />
220 kPa<br />
Present/ChgOK<br />
Not present<br />
present<br />
Control bit for EEPROM writing 0 or 1<br />
OPTION CODING<br />
Not present<br />
Not present<br />
Not present or Present<br />
Type0 or Type1<br />
Not present<br />
Present/Chg OK<br />
Not present<br />
Not available<br />
Not present<br />
Not available or Available<br />
Not present or Present<br />
NOTE:<br />
⦆*1 : TPMS is an abbreviation of Tire Pressure Monitoring<br />
System, DRL of Daytime Running Light, AFS of Adaptive<br />
Front lighting System, and ARS of Advanced Rear lighting<br />
System. However, the systems are not used for this vehicle.<br />
⦆*2 : The setting can be changed by the option coding. Refer to.<br />
⦆*3 : The item is actually installed to a vehicle, but its initial<br />
setting is "Not present." This is because the item does not<br />
adapt CAN, and does not indicate abnormal coding data.<br />
Required Special Tools:<br />
⦆MB991958: Scan Tool (M.U.T.-III Sub Assembly)<br />
⦆MB991824: Vehicles Communication Interface (V.C.I.)<br />
⦆MB991827: M.U.T.-III USB Cable<br />
⦆MB991910: M.U.T.-III Main Harness A (Vehicles with CAN communication system)<br />
If there is any item indicated by the option coding after<br />
equipment change, set ETACS-ECU so that the option<br />
coding data corresponds with the equipment content.<br />
Functions and systems do not work normally if the setting<br />
does not correspond with the equipment.