British Aerospace Hawk Mk. 51 Construction Guide - Velocity-RC.com

More documents

Recommendations

Info

BAe Hawk Mk. 51 : 70mm Sport Jet Construction Guide v1.3 Rear Hatch Attachment: I chose to use strong magnets for the canopy hold downs. I also did the same for the rear hatch. 1 Epoxy pieces of scrap balsa block at the four corners of the rear hatch. Some shaping and fitting will be required before final gluing. 2 Recess and epoxy a rare earth magnet into each block so that it is flush with the fuselage when the hatch is attached. 3 Install mating magnets on the fuselage side and reinforce (from the backside) with epoxy/filler to hold them in place. Page 34 of 47
BAe Hawk Mk. 51 : 70mm Sport Jet Construction Guide v1.3 Retractable Landing Gear: Nose Install 1 Cut out the nose door outline at the front (underside) of the fuse. Follow the panel lines plus 15mm at the rear of the door. 2 Assemble the nose gear mounting formers as shown. Page 35 of 47
Page 1 and 2: BAe Hawk Mk. 51 : 70mm Sport Jet Co
Page 33: BAe Hawk Mk. 51 : 70mm Sport Jet Co
Page 47: BAe Hawk Mk. 51 : 70mm Sport Jet Co

British Aerospace Hawk Mk. 51 Construction Guide - Velocity-RC.com

Create successful ePaper yourself

Delete template?

Save as template?