Engineering Reference Manual 2010 - Hillphoenix

O2.5UM
(5” BASEFRAME)
EXTENDED STANDARD FRONT
12" INTERNATIONAL DELI
STYLE FRONT
3" INTERNATIONAL DELI
STYLE FRONT
(for additional rear sill options refer to the
Merchandisers Accessories Guide)
LIGHTED REAR SILL
(OPTIONAL)
LOAD LIMIT
LINE
STANDARD
FRONT
19 15/16 in
[50.7 cm]
24 1/8 in
[61.4 cm]
8 15/16 in
[22.6 cm]
26 1/16 in
[66.1 cm]
8 15/16 in
[22.6 cm]
18 15/16 in
[48.1 cm]
12"
18"
21 in
[53.3 cm]
4" SOLID FRONT
6" THERMOPANE FRONT
6" PLEXIGLAS FRONT
44 1/16 in
[111.9 cm]
44 1/16 in
[111.9 cm]
32 1/4 in [81.9 cm]
COIL
PLENUM
21 3/16 in
[53.8 cm]
17 in
[43.2 cm]
17 in
[43.2 cm]
25 7/16 in
[64.6 cm]
17 in
[43.2 cm]
27 5/16 in
[69.3 cm]
17 in
[43.2 cm]
27 1/8 in
[68.9 cm]
5 1/8 in
[13.1 cm]
4 in [10.2 cm]*
31 9/16 in [80.2 cm]
36 7/16 in [92.6 cm]
43 1/4 in [109.9 cm]
REAR REFRIGERATION
(13 15/16" off of floor)
4 in [10.2 cm]
43 1/4 in
[109.9 cm]
36 7/16 in
[92.6 cm]
16 in
[40.6 cm]
31 9/16 in
[80.2 cm]
WIRING-TO-TRAY
(STANDARD)
(Connection must be
flexible to front of case)
1 1/2" PVC DRAIN
CONNECTION
(6', 8', 12' cases)
33 9/16 in
[85.2 cm]
**
C
FRONT
L
OF CASE
1 1/2" PVC DRAIN
CONNECTION
(4' case only)
48 in [121.9 cm] {4' case}
72 in [182.9 cm] {6' case}
96 in [243.8 cm] {8' case}
144 in [365.8 cm] {12' case}
REFRIGERATION
(4' case only)
22 3/4 in
[57.8 cm]
28 5/8 in
[72.7 cm]
KICK PLATE
LOCATION
REFRIGERATION
(6', 8', 12' cases)
1 1/2 in [3.8 cm]
{END}
8 11/16 in [22.1 cm]
12 in [30.5 cm]
NOTES:
* STUB-UP AREA
** RECOMMENDED STUB-UP CENTERLINE FOR ELECTRICAL AND HUB DRAINS
• FRONT AND REAR SILL HEIGHTS VARY WITH BASEFRAME HEIGHT
• ENDS ADD APPROXIMATELY 1 INCH TO CASE HEIGHT
• A 2" MINIMUM AIR GAP IS REQUIRED BETWEEN THE REAR OF THE CASE AND A WALL
• AVAILABLE SHELF SIZES: 10", 12", 14", 16" & 18"
• PRODUCT ON TOP SHELF SHOULD BE 3" BELOW DISCHARGE
• RECOMMENDED SHELF CONFIGURATION IN ROWS: 1-12" & 1-18"
• DASHED LINES SIGNIFY AREA INSIDE BASE RAIL BEHIND KICK-PLATE
COMPONENT
42 05/10