DISC MOWER CONDITIONERS - Challenger
DISC MOWER CONDITIONERS - Challenger
DISC MOWER CONDITIONERS - Challenger
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>DISC</strong> <strong>MOWER</strong> <strong>CONDITIONERS</strong><br />
<strong>DISC</strong> <strong>MOWER</strong> <strong>CONDITIONERS</strong><br />
<strong>DISC</strong> <strong>MOWER</strong><br />
<strong>CONDITIONERS</strong><br />
PTD Series Specifications
SPECIFICATIONS<br />
<strong>DISC</strong> <strong>MOWER</strong> <strong>CONDITIONERS</strong><br />
MODEL PTD12B PTD15B<br />
Frame Configuration Center-pivot Center-pivot<br />
Cutting width 12 ft. (3658 mm) 15 ft. 3 in. (4648 mm)<br />
Overall width 150 in. (3810 mm) 186 in. (4724 mm)<br />
Overall length 23 ft. 8 in. (7214 mm) 30 ft. (9144 mm)<br />
Weight 5885 lbs. (2669 kg) 7010 lbs. (3180 kg)<br />
<strong>DISC</strong> Cutterbed<br />
Cutterbed design Spur gear Spur gear<br />
Cutting height 1.3 to 3 in. (32 to 76 mm) 1.3 to 3 in. (32 to 76 mm)<br />
Number of discs 8 10<br />
Number of knives 16 (2 per disc) 20 (2 per disc)<br />
Disc speed 2600 rpm 2600 rpm<br />
Knife tip speed 184 mph (296 km/h) 184 mph (296 km/h)<br />
Knives Swingaway, reversible Swingaway, reversible<br />
Hay Conditioner Type Rubber on steel, Steel on steel<br />
Steel on steel, Spoke<br />
Length 110 in. (2794 mm) 110 in. (2794 mm)<br />
Speed 1100 rpm 1280 rpm<br />
roll separation Adjustable Adjustable<br />
Tractor Requirements<br />
Minimum Horsepower 85 PTO hp (63 kW) 120 PTO hp (89 kW)<br />
PTO 1000 rpm 1000 rpm<br />
WINDROW WIDTH 36 to 106 in. 40 to 96 in.<br />
914 to 2692 mm) (1016 to 2438 mm)<br />
Optional Equipment High skid shoes High skid shoes<br />
Hydraulic header tilt<br />
Top shield protector<br />
Top shield protector<br />
High speed conditioner<br />
(Spoke conditioner)<br />
© 2008 AGCO Corporation. AGCO ® is a registered trademark of AGCO Corporation. Caterpillar ® , Cat ® , ACERT ® and <strong>Challenger</strong> ® are registered trademarks of Caterpillar Inc. AGCO Corporation has a corporate policy of continuous product improvement and development; therefore, specifications are subject to change<br />
without any advance notice. AGCO Corporation is not responsible for differences between the specifications or illustrations contained in this publication and the actual equipment. Equipment produced by other manufacturers is shown in photographs in this brochure for the purpose of illustration only and is not<br />
intended as an endorsement of that particular equipment or its suitability. All rights reserved. AGCO Corporation, 4205 River Green Parkway, Duluth, GA 30096 CH08362 (04) 3 PD
Change language