Suburban Furnace Service Manual - BR Wholesale RV & Marine

More documents

Recommendations

Info

VENTING Venting- By definition of a Direct Vent Sealed Combustion <strong>Furnace</strong>, it must be vented to the outside atmosphere and also draw combustion air from outdoors. Therefore, it is imperative that the vent be unobstructed and there must be a seal between the exhaust and intake (caulking) . Refer to the vent assembly installation in the manual. The vent must be straight. There can be no offsets or turns in the vent. All vent tubes which connect to the furnace exhaust and intake must overlap a minimum of 1/2" on intake, and 1 1/4" on exhaust. Check your furnace model number for vent installation procedures. Vents cannot be altered as supplied from the factory. VENT ASSEMBLY INSTALLATION (SF and SH SERIES) Figure 2 SF Figure 2A SH 6
VENT ASSEMBLY INSTALLATION (SF and SH SERIES) Figure 3 SF Figure 3A SH and SHD-2542 7
Page 1 and 2: Suburban RV FURNACES SERVICE MANUAL
Page 3 and 4: GENERAL SERVICE INFORMATION Suburba
Page 5: INSTALLATION There are several impo
Page 9 and 10: VENT ASSEMBLY INSTALLATION (SFV) Fi
Page 11 and 12: VENT ASSEMBLY INSTALLATION (DD SERI
Page 13 and 14: VENT ASSEMBLY INSTALLATION (NT SERI
Page 15 and 16: VENT ASSEMBLY INSTALLATION (NT-40 a
Page 17 and 18: DUCTING Ducting - Suburban furnaces
Page 19 and 20: SF-20/20F 1" 0" 0" 0" 0" 0" 2-4" 56
Page 21 and 22: FURNACE SPECIFICATIONS 12 VDC Model
Page 23 and 24: SEQUENCE OF OPERATION For Furnaces
Page 25 and 26: Sequence of Operation for 24 VAC Fa
Page 27 and 28: TROUBLE SHOOTING GUIDE SUBURBAN RV
Page 29 and 30: SERVICE HINTS, DIAGNOSIS, AND CORRE
Page 31: Figure 23 Remote Flame Sense With T
Page 34 and 35: Figure 30 Fan Control Board P-40 34
Page 36 and 37: FURNACE REMOVAL SF-20/25/30/35/42,
Page 38 and 39: NT ELECTRODE GAP SPECIFICATIONS AND
Page 40: CAUTIONS & SAFETY INFORMATION 1. Ne

Suburban Furnace Service Manual - BR Wholesale RV & Marine

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?