Oakton Temp 300 Thermocouple Datalogging Thermometer Manual

More documents

Recommendations

Info

5. INSERTING AND REMOVING OPTIONAL RUBBER ARMOUR 1. To insert thermometer into the optional rubber armor, slide in from the top of meter before pushing the bottom edges of meter down to set it into position. Lift up the stand at the back of meter for bench top applications if necessary. 2. To remove thermometer from armor, push out from the bottom edges of meter until it is completely out of boot. - 7 -
6. ASSEMBLING OPTIONAL HANDSFREE ACCESORIES You can use the optional magnets and strap in the Handsfree Kit accessories for hands free operations. - 8 -
Page 1: Instruction Manual Temp-100 and Tem
Page 4 and 5: 1. INTRODUCTION This versatile hand
Page 6 and 7: 3. SPECIFICATIONS Thermocouple Ther
Page 8 and 9: Storage -40°C to 65°C (-40°F to
Page 12 and 13: 7. CONNECTING A THERMOCOUPLE Use th
Page 14 and 15: 8. KEY FUNCTIONS F1 F2 F3 hold on/o
Page 16 and 17: 10. MEASUREMENT MODE On initial sta
Page 18 and 19: 14. SETUP MODE To access the setup
Page 20 and 21: On the second page you can set auto
Page 22 and 23: Select calibration method by pressi
Page 24 and 25: 17. ALARMS SCREEN Disable or enable
Page 26 and 27: Once the USB connection is establis
Page 28 and 29: 21. MAINTENANCE Properly used, the
Page 30 and 31: 25. ACCESSORIES Replacement Meters
Page 32 and 33: 28. INNOCAL® CALIBRATION AND REPAI
Page 34: With today's high quality standards

Oakton Temp 300 Thermocouple Datalogging Thermometer Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?