0005-2000 res. manual

More documents

Recommendations

Info

(Mounting Instructions, continued) This assembly can now be screwed in place of the phase plug in the middle of the midrange. Feed the tweeter wires out the backplate of the midrange and through the slot that guides them to the side of the magnet. Putting the magnet boot back on will hold the wires in place. A special grill included in this kit accommodates the pole-mounted tweeter when this system is used in custom mounting locations. WIRING There are three sets of wires supplied with your system. One set has two different size female connectors (.205" and .110") on one end and is designed to plug on to the terminals of the midrange driver. The other end of this wire goes to the midrange output terminals on the supplied crossover. Two sets of wires with no connectors on either end are also supplied. One set will go from the tweeter output terminals on the crossover to the tweeter itself. This wire and the short wire coming out of the tweeter are joined using the butt connectors. The last set of wires is used to connect the output of your source unit to the input terminals of the crossover. Crossover Source - + - + - + + Tweeter Midrange - + - + - 6
ADJUSTMENT It is quite common in car stereo systems for the tweeter to seem dominant due to restrictions on the availability of good mounting locations for the midrange.The Resolution System crossover has an adjustable tweeter level control that is designed for level matching once the system is installed and operating. Starting with the level adjustment in the 0dB position, listen to the system with a variety of music. If the tweeters sound too loud or too soft in relation to the other drivers, simply change the level setting of both crossovers to a different level of attenuation. Repeat this procedure until a balance you prefer is reached between the outputs of your tweeters and midrange drivers. If you have more questions about the installation of your KICKER component, see the Authorized KICKER Dealer where you made your purchase. You may also call our Technical Services Line at (405)624-8583 or contact us via the Technical Services page on www.kicker.com. 7
Page 1 and 2: RS6, RS5, & RS4 Resolution Matched
Page 3 and 4: MIDRANGE DRIVER MOUNTING The easies
Page 5: (Mounting Instructions, continued)

0005-2000 res. manual

Create successful ePaper yourself

Delete template?

Save as template?