Multimat®NT Multimat®NT press - DeguDent

2 Safety instructions
All DeguDent GmbH devices are designed and produced using state-of-the-art technology and following all
recognize safety rules.
Nevertheless, using these devices may result in hazards to operators or third parties or damage to the
Multimat ® NT/NT press or other property, e.g. if:
• The unit is operated by untrained or not properly instructed personnel.
• The unit is not employed for its proper uses.
• The unit has not been properly operated or maintained.
Use only qualified and trained personnel to perform to tasks described in these Instructions for Use. Observe
any applicable legal age restrictions!
Personnel to be trained or guided, including vocational trainees, must work with the Multimat ® NT/NT press only
if supervised by an experienced operator!
2.1 Safe transport
The unit weighs 22 kg (Multimat ® NT) / 24.6 kg (Multimat ® NT press) and must be lifted and transported by two
persons.
The unit is shipped in a cardboard case and is protected by an upper and a lower interior foam shell. These
shells are designed such that the firing base is also protected from shock by an elastic foam element. When
repackaging the unit, make sure that this protective foam element is properly in place.
2.2 Safe operation
To ensure safe operation of the unit, read and follow the following instructions:
Do not place the Multimat ® NT/NT press and the vacuum pump (available separately) in the immediate vicinity
of sources of heat to prevent overheating of the unit.
Keep the device clear of the nearest wall or object. The minimum distance is 25 to 30 cm.
Place the device only on non-flammable surfaces. Keep flammable objects and liquids away from the device.
Position the vacuum pump such that adequate ventilation is assured.
Protect the unit from moisture and steam.
Ensure that the unit and the vacuum pump (available separately) are connected only to the appropriate mains
voltage.
Never open the unit under any circumstances. Electric shock hazard!
If the Multimat ® NT/NT press is not to be used for an extended period, disconnect the unit from mains.
Do not operate the unit unless it is firmly placed on the firing/pressing base to avoid excessive wear and tear on
the seals of the firing platform, which might even result in deformation of the carrier plate.
Page 6