Bulletin 190 Civil Engineering Testing Equipment - Tinius Olsen

SOIL
TO-202-100-03 Core Cutting and
Grinding for up to 100mm diameter
Specimens, 415 V, 50 Hz
TO-202-150-02 Core Cutting and
Grinding for up to 150mm diameter
Specimens, 415 V, 60 Hz
TO-202-150-03 Core Cutting and
Grinding for up to 150mm diameter
Specimens, 415 V, 50 Hz
Point Load Index Tester
Key Features
• Rock core specimens can be tested
without any preparation.
• The instrument can be used in the
laboratory as well as at the drilling site.
• Results may also be used to predict
the uni axial compressive strength of
rock.
• A wide range of core sizes can be
tested.
• The selected (which is any one
unit via SI, Metric or Imperial fixed)
engineering unit will be displayed on
the front panel through LED.
• Peak load displayed on sample failure
• 4 key buttons to Program, Start, Stop,
Set Break Point, and Zero.
• Battery or mains operation
• Failure detection definable
Relevant Standards
EN DD ENV 1997-2, ASTM D-5731
Description
Point Load Index Tester is used for
determining the Diametral Point Load
Strength Index of rock cores and irregular
lumps, which can be tested without
any treatment. The Point Load Test
is primarily an Index Test for strength
classification of rock materials. This
instrument is mainly intended for field
measurements on rock specimen but it
can also be used in the laboratory. The
results of the test may also be used to
predict the uniaxial compressive strength
of rock from correlations. The apparatus
is light and portable. It can be used in the
laboratory as well as in the field.
Ordering Information
TO-206-1-ECO Point Load Index Tester
with ECO Digital Read out
107
Contact us at: sales@TiniusOlsen.com