Bulletin 190 Civil Engineering Testing Equipment - Tinius Olsen

Curing Tank
Key Features
• 24-hour cycle from time of mixing
• Temperature range : Ambient + 5°C
to 100°C
• Accuracy of ± 2°C
System Description
The fully insulated water tank holds
standard up to 36 150 mm cast cubes
or 72 of the 70.6 mm cast cubes. These
cubes are placed on two removable racks
with sufficient free circulation of water
around each cube. An immersion heater
heats the tank and the temperature is
controlled at 35°C or 100°C ±2°C, or,
optionally, a refrigeration system can be
used to cure grey cement. The pump,
drain valves, heater, thermostat, and
recirculation pump are housed in a
compartment located at tank’s one end.
TO-355-1-03 Curing Tank for 6/12 molds
of 150mm/70.6mm size, 220V, 50Hz
TO-355-2-01 Curing Tank for 12/24
molds of 150mm/70.6mm size,
110V, 60Hz
TO-355-2-02 Curing Tank for 12/24
molds of 150mm/70.6mm size,
220V, 60Hz
TO-355-2-03 Curing Tank for 12/24
molds of 150mm/70.6mm size,
220V, 50Hz
TO-355-3-02 Curing Tank for 24/48
molds of 150mm/70.6mm size,
415V, 60Hz
TO-355-3-03 Curing Tank for 24/48
molds of 150mm/70.6mm size,
415V, 50Hz
TO-355-4-02 Curing Tank for 36/72
molds of 150mm/70.6mm size,
415V, 60Hz
TO-355-4-03 Curing Tank for 36/72
molds of 150mm/70.6mm size,
415V, 50Hz
Applicable Standards
EN 12390-2, ASTM C31, C192, AASHTO
T23
Ordering Information
TO-355-1-01 Curing Tank for 6/12 molds
of 150mm/70.6mm size, 110V, 60Hz
TO-355-1-02 Curing Tank for 6/12 molds
of 150mm/70.6mm size, 220V, 60Hz
www.TestingConcrete.com 36