Green Diode-Pumped Solid-State Laser Systems (Hardware)
Green Diode-Pumped Solid-State Laser Systems (Hardware)
Green Diode-Pumped Solid-State Laser Systems (Hardware)
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Initial Installation<br />
• Ensure that the shorting connector is firmly in place on the laser power<br />
connector.<br />
• Inspect all cables and connectors for bent or broken pins and broken<br />
wires.<br />
• Check packing list to ensure that all items are present.<br />
2.2 Identifying Components<br />
The following components, along with any options, should always be<br />
included in your shipment.<br />
1. 58 Series green DPSS laser head. There are several different models.<br />
Check the factory label on the laser head and the final test data sheet to<br />
determine that you have received the correct unit.<br />
2. Model 58 PSM 290 Power Supply. Check the setup label on the<br />
bottom of the unit to verify that you have the correct supply for the<br />
laser head.<br />
Power supplies are programmed for specific laser heads. Power supplies<br />
and laser heads are not interchangeable. Using the incorrect power supply<br />
with a laser head may cause severe and permanent damage to the laser.<br />
Such damage is not covered under the Melles Griot warranty.<br />
3. Power cable (permanently attached to the laser head).<br />
4. Signal cable (permanently attached to the laser head).<br />
5. Shorting connector. This connector is installed on the power cable<br />
(item 3) to prevent damage from electrostatic discharge (ESD). If this<br />
connector is not firmly in place when the system is unpacked, contact<br />
the factory immediately.<br />
6. Power cord (US shipments only).<br />
7. Final Inspection Data Sheet. This document shows the laser<br />
performance and quality checks at the factory, prior to shipment.<br />
8. Operator's manual.<br />
9. Keys (two). These are used to operate the power supply.<br />
In addition to the items mentioned above, which should be included in<br />
every shipment, the following accessories may have been ordered. For<br />
more information about these accessories, see Appendix B.<br />
• 58 ASG XXX collimator (for 58 GSS and 58 GLS series)<br />
Please call your Melles Griot representative if you have any questions<br />
about the options or components supplied with this laser system.<br />
10